1998-2002 Pontiac Firebird - STS Subterranean Turbo System Installation - Part 2
|
Upon reinstallation, ensure the block-off plate-mounting surface is clean and the factory O-ring gasket is in place. Mount the plate upside down, making certain that the 45-degree oil feed line fitting is pointed to the rear of the vehicle. Tighten the two 10mm bolts and then tighten the -4-AN line with a 91/416-inch wrench and route it along the left-hand side of the transmission tunnel to the rear of the car. Mount the stainless braided line to the oil inlet on the turbo-charger's bearing housing or centersection. A check valve ensures oil doesn't enter the housing unless it is pressurized. View Related Article
|
|