Maximum-Effort Fourth-Gen10-Bolt
|
Before installing the cover, the optional TA stud kit is installed. The studs effectively replace the main cap bolts, allowing additional clamping force. A 51/48-inch socket is used to break the four cap bolts loose, but only one bolt at a time is removed. Loctite is applied to the replacement TA stud, and a 31/416-inch Allen wrench is used to tighten the stud to approximately 10 ft-lbs. This procedure is repeated until all of the TA studs are in place. The bearing caps are reinstalled and torqued to 55 ft-lbs using the supplied TA Performance washers and nuts. View Related Article
|
|
|
|