Building A Carburetor For Under 20 Drill
|
The legs for the stand are constructed of ¾-inch dowel rod (Lowe’s, PN 19348, retail $2.64). Floyd marked and cut four 6-inch sections of the dowel, placed them in each of the four holes of the base, and measured and adjusted for height by either drilling a bit deeper into the wood or putting some wood shavings in the hole. Once satisfied that the legs were the same height, he placed the carburetor onto the legs and drilled a ½-inch-deep, 21⁄64-inch hole into the center of each dowel for the leg pins. View Related Article
|
|
|
|