Racekrafters 467Ci Stroker Manifold
|
[15] Cory port-matched the Edelbrock Torker II manifold prior to installation to compliment the massaged 6X cylinder heads. Craig and Bob specified this manifold: “It has the cross-sectional area to match head flow and displacement.” Craig first test-fit it without the front seal and then with it to ensure that the recess in the intake was deep enough and bolt holes lined up. When he installed it, he used Locktite Aviation gasket sealant (PN 30516) on the gaskets and on the bolt threads so oil can’t wick up. He inserted all of the bolts and just started to thread them in. He then tightened the front bolt at the water pump to draw the intake forward just a bit to make that front seal, well, seal. He then torqued the bolts to 20 ft-lb in a crisscross X-pattern working from the center out. View Related Article
|
|
|
|